Microcom 470 Manual do Operador descarregar pdf (Página 54)

Printer Commands Chapter 5

))))))))))))))))))))))))))))))))))))))))))))

470 Operators Manual

^A ^D Command

23 Change SW3: Software dip switch #3. Below is the ^AB sequence:

12345678

^ABxxxxxxxx

*******.

Not Used

******.)

1=Temp in Fahrenheit, 0=Celsius

*****.))

1=Ribbon Break Sensor Disable, 0=Enable

****.)))

1=Pulse Tone On Piezo, 0=Continuous

***.))))

1=Head Up Error Disable, 0=Enable

**.)))))

1=Response After Print Enable, 0=Disable

*.))))))

1=User Display Enable, 0=Disable

.)))))))

1=Piezo Sound Disable, 0=Enable

Position:

1 Piezo Sound: If set to 1, the piezo is disabled.

2 User Display: If enabled, the printer will display a programmable message

instead of the factory default (see ^D77).

3 Response After Print: If enabled, an enquiry response will be sent back

through the communications port after every print.

4 Head Up Error: If set to 1, head up error checking is disabled.

5 Pulse Tone On Piezo: If set to 1, the piezo is disabled.

6 Ribbon Break Sensor: If disabled, no error will occur if ribbon is out.

7 Temp Display Selection: If set to 1, temperature will be displayed in Fahrenheit

degrees instead of Celsius.

8 Not Used

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 123 124

Sem comentários

Microcom 470 Manual do Operador Página 54