Microcom 400 Manual do Operador descarregar pdf (Página 48)

Printer Commands Chapter 5

400 Operators Manual

5.3.1 SOFTWARE DIP SWITCHES AND EEPROM COMMANDS

The following commands are different from the other printer commands in that they are stored in

EEPROM, are non-volatile and configure the machine upon power-up. Once sent to the printer,

they do not need to be sent again.

The printer will only configure to the following commands after a the machine has been powered

off and then turned back on. The printer will not accept these commands until this is done.

^A ^D COMMAND

20 Change baud rate: Unless otherwise requested by the customer, the baud rate of

a 400 printer, out of the box, is 9600. (i.e. to change baud to 19200 use ^A8^D205)

0 110 Baud

1 150 Baud

2 300 Baud

3 600 Baud

4 1200 Baud

5 2400 Baud

6 4800 Baud

7 9600 Baud

8 19200 Baud

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 99 100

Sem comentários

Microcom 400 Manual do Operador Página 48